copper slag sand replacement

(PDF) Copper slag as sand replacement for high

Addition of up to 50% of copper slag as sand replacement yielded comparable High performance concrete Copper slag strength with that of the control mix. However, further additions of copper slag caused reduction in the Waste material strength due to an increase of the free water content in the mix.

More

Effect Of Copper Slag As A Sand Replacement On The ...

2018-9-24  Copper Slag as a Sand Replacement can be used due to the following reasons: It has a high Compressive strength which is equal to that of Fine Aggregate with similar diameter. Copper Slag is a non-degradable matter; it is creating an environmental problem so when used as a Replacement for

More

Copper slag as sand replacement for high performance ...

Therefore, it is recommended that 40 wt% of copper slag can used as replacement of sand in order to obtain HPC with good strength and durability properties. AB - This paper reports on an experimental program to investigate the effect of using copper slag as a replacement of sand on the properties of high performance concrete (HPC).

More

(PDF) Effect of Copper Slag as a Sand Replacement on the ...

replacement of Copper Slag with sand. It was observed that Maximum compressive strength and tensile strength of copper slag concrete increased by 8.11% and 7.58% for 40% replacement more than cont ...

More

Replacing River Sand with Granulated Copper Slag ... -

2016-9-9  Granulated Copper Slag as a patial replacement for sand. r Fifteen concrete mixes with different proportions of Granulat-ed Copper Slag ranging from 0% (for the control mix) to 100% were considered. All the mixes were proportioned by the method of absolute volumes considering the specific grav ity of the constituent materials.

More

Studies on use of Copper Slag as Replacement Material for ...

2014-8-20  This work focuses on the use of copper slag, as a partial replacement of sand for use in cement concrete and building construction. Cement mortar mixtures prepared with fine aggregate made up of different proportions of copper slag and sand were tested for use as masonry mortars and plastering. Three masonry wall panels of dimensions 1 × 1 m were plastered. The studies showed that

More

Studies on use of Copper Slag as Replacement Material

2017-8-28  replacement material for river sand • Use of copper slag as replacement material for river sand in cement concrete (0, 25, 50, 75 and 100 %) Materials Cement and Copper Slag In the present investigation, ordinary Portland cement of 53 grade was used. Fine aggregate used for control mortar and

More

Effect of copper slag as fine aggregate replacement in ...

2019-1-1  The objective of the present study is to utilize high volume copper slag (i.e. 100%) as a replacement to fine aggregate and partially replacing cement with Nano silica. The work is carried out in two phases. In the first phase, the fine aggregate is replaced with copper slag in different percentages of 20%, 40%, 60%, 80%, and 100%.

More

PERFORMANCE OF CONCRETE MADE WITH THE COPPER

2020-11-21  partial replacement of sand by Copper Slag at 7 days curing period Designation Replacement of fine aggregate by copper slag (%) 2 7th day Compressive strength (N/mm ) S-1 0 26.07 S-2 20 29.8 S-3 40 32.02 S-4 60 27.53 S-5 80 25.71 Table-6: Cube Compressive Strength of concrete with partial replacement of sand by Copper Slag at 28 days

More

International Journal of Technical Innovation in Modern ...

2019-4-2  Hence this research work is carried out for optimum replacement of sand by copper slag. Copper slag is an industrial by-product material produced during the process of manufacturing and refining of copper. To produce 1 ton of copper, approximately 2.2

More

[PDF] Performance of Copper slag and ferrous slag as ...

Corpus ID: 112031287. Performance of Copper slag and ferrous slag as partial replacement of sand in Concrete @article{Sudarvizhi2011PerformanceOC, title={Performance of Copper slag and ferrous slag as partial replacement of sand in Concrete}, author={S. Sudarvizhi and R. Ilangovan}, journal={International Journal of Civil and Structural Engineering}, year={2011}, volume={1},

More

(PDF) USE OF COPPER SLAG AS A REPLACEMENT FOR FINE ...

Leaching studies demonstrate that granulated copper slag does not pave way for leaching of harmful elements like copper and iron present in slag. The percentage replacement of sand by granulated ...

More

(PDF) Copper slag as sand replacement for high

Addition of up to 50% of copper slag as sand replacement yielded comparable High performance concrete Copper slag strength with that of the control mix. However, further additions of copper slag caused reduction in the Waste material strength due to an increase of the free water content in the mix.

More

Studies on use of Copper Slag as Replacement Material

2017-8-28  replacement material for river sand • Use of copper slag as replacement material for river sand in cement concrete (0, 25, 50, 75 and 100 %) Materials Cement and Copper Slag In the present investigation, ordinary Portland cement of 53 grade was used. Fine aggregate used for control mortar and

More

Performance of copper slag and ferrous slag as partial ...

Request PDF On Jan 1, 2011, S.S. Meenakshi and others published Performance of copper slag and ferrous slag as partial replacement of sand in concrete Find, read and cite all the research you ...

More

[PDF] Performance of Copper slag and ferrous slag as ...

Corpus ID: 112031287. Performance of Copper slag and ferrous slag as partial replacement of sand in Concrete @article{Sudarvizhi2011PerformanceOC, title={Performance of Copper slag and ferrous slag as partial replacement of sand in Concrete}, author={S. Sudarvizhi and R. Ilangovan}, journal={International Journal of Civil and Structural Engineering}, year={2011}, volume={1},

More

(PDF) USE OF COPPER SLAG AS A REPLACEMENT FOR FINE ...

Leaching studies demonstrate that granulated copper slag does not pave way for leaching of harmful elements like copper and iron present in slag. The percentage replacement of sand by granulated ...

More

Durability Study of Concrete Containing Copper Slag as a ...

2016-7-7  Copper slag as a replacement of sand that concrete exhibits enhanced mechanical properties with reference to conventional concrete. Key words: Copper Slag, Durability, Sand Replacement, Acid Attack Test and Water Absorption Test I. INTRODUCTION Concrete is one of the major construction materials being ...

More

Effect of copper slag as fine aggregate replacement in ...

2019-1-1  The objective of the present study is to utilize high volume copper slag (i.e. 100%) as a replacement to fine aggregate and partially replacing cement with Nano silica. The work is carried out in two phases. In the first phase, the fine aggregate is replaced with copper slag in different percentages of 20%, 40%, 60%, 80%, and 100%.

More

STUDY ON HIGH STRENGTH CONCRETE BY USING

2021-1-7  of copper slag as sand replacement yielded comparable strength with control mix. K.Mahendran, N.Arunachelam Geopolymer Concrete with copper slag an industrial by-products as a replacement of fine aggregates was studied. The properties of six different proportions with control mix concrete and others were 10 %, 20 %, 30 %, 40 % and 50 % ...

More

International Journal of Technical Innovation in Modern ...

2019-4-2  Hence this research work is carried out for optimum replacement of sand by copper slag. Copper slag is an industrial by-product material produced during the process of manufacturing and refining of copper. To produce 1 ton of copper, approximately 2.2

More

5 IV April 2017 doi/10.22214/ijraset.2017

Copper Slag, Fly Ash, Carbonate Sand etc. having silica composition (SiO2) could be used as a replacement for Fine aggregate in concrete mix. Copper slag is an industrial by product material produced from the process of manufacturing copper.

More

Use of Copper Slag and Fly Ash in High Strength Concrete

2020-4-1  at 20% incremental copper slag by weight replacement of sand from 0% to 100%. The results indicated that the strength of the concrete with less than 40% copper slag replacement was higher than or equal to that of the control specimen and the workability even had a dramatic growth. Mostafa Khanzadi, Ali Behnood (2009) presents the

More

Development Regarding Foundry Sand Concrete

The replacement of river sand by copper slag is possible in concrete mix. For M 20 and M 25 grade concrete, the optimum sand replacement proportion is generally 35- 40%. Moreover, generally the ...

More

(PDF) Copper slag as sand replacement for high

Addition of up to 50% of copper slag as sand replacement yielded comparable High performance concrete Copper slag strength with that of the control mix. However, further additions of copper slag caused reduction in the Waste material strength due to an increase of the free water content in the mix.

More

Copper Slag Sand Suppliers, all Quality Copper Slag Sand ...

Copper Slag Sand, Copper Slag Sand Suppliers Directory - Find variety Copper Slag Sand Suppliers, Manufacturers, Companies from around the World at copper scrap ,copper wire ,copper coil, Abrasives

More

A Review on Partial Substitution of Copper Slag with

2019-7-1  copper slag as a substitution replacement material of sand. Copper slag which is an industrial waste product can be used as replacement for cement with sand and contributes to the increase in various mechanical properties of concrete. Copper slag can be used up to 30% but when used ahead of 50% results in decrease in strengths. [13]

More

[PDF] Performance of Copper slag and ferrous slag as ...

Corpus ID: 112031287. Performance of Copper slag and ferrous slag as partial replacement of sand in Concrete @article{Sudarvizhi2011PerformanceOC, title={Performance of Copper slag and ferrous slag as partial replacement of sand in Concrete}, author={S. Sudarvizhi and R. Ilangovan}, journal={International Journal of Civil and Structural Engineering}, year={2011}, volume={1},

More

STRENGTH AND DURABILITY STUDY OF GEOPOLYMER

2019-7-19  STRENGTH AND DURABILITY STUDY OF GEOPOLYMER CONCRETE WITH 100% REPLACEMENT OF SAND USING COPPER SLAG Sivaranjani.S., Sridhar. M. Abstract— One of the regularly used man made building material in the word is concrete.

More

Effect of copper slag as fine aggregate replacement in ...

2019-1-1  The objective of the present study is to utilize high volume copper slag (i.e. 100%) as a replacement to fine aggregate and partially replacing cement with Nano silica. The work is carried out in two phases. In the first phase, the fine aggregate is replaced with copper slag in different percentages of 20%, 40%, 60%, 80%, and 100%.

More

ISSN 2465-7964 Vol. 7, No. 1, June 2021 eISSN 2465-7972

2021-9-1  sand with copper slag as fine aggregate. In this study, M40 grade concrete was evaluated. In their experi-mental study, copper slag was used to replace 0 to 50% of fine aggregate (by weight) in concrete. The study's finding indicated that workability in terms of slump increases with an increase in replacement per-centages of copper slag.

More

Applying Solid Residues of Copper Slag in Kerman ...

2021-11-5  Al -Jabri et al. (2009) used copper slag as a sand replacement for provide the high-performance concrete. They found that the efficiency and strength up to 50 percent replacement of sand with copper slag increased and Water absorption was decreased up to 40%. Fadaee et al. (2014) studied the properties of concrete made using slag of Sarcheshmeh ...

More

Use of Copper Slag and Fly Ash in High Strength Concrete

2020-4-1  at 20% incremental copper slag by weight replacement of sand from 0% to 100%. The results indicated that the strength of the concrete with less than 40% copper slag replacement was higher than or equal to that of the control specimen and the workability even had a dramatic growth. Mostafa Khanzadi, Ali Behnood (2009) presents the

More

By-Products Sterlite Copper (A Unit of Vedanta Limited)

Ferro Sand (Copper Slag) Ferro Sand (also known as Copper Slag) is a by-product generated during pyro-metallurgical process to produce Copper. Sterlite Copper produce approximately 6,00,000 MT of Copper Slag per annum. Ferro Sand is non-toxic, non-leachable and non hazardous material in nature. Central Pollution Control Board (CPCB) has ...

More

Study on Strength of High Performance Concrete by

2019-6-19  copper slag as a replacement of sand. The M50 grade concrete used was designed by using modified ACI method. There are 5 concrete were prepared with different proportions of copper slag as a replacement of sand ranging from 45% to 60%. This mixes were evaluated for compressive strength, split tensile strength and flexural strength.

More

(PDF) USE OF COPPER SLAG IN CONCRETE AND CEMENT

USE OF COPPER SLAG IN CONCRETE AND CEMENT MORTAR AS REPLACEMENT OF SAND. Download. Related Papers. Effect of Copper Slag As A Fine Aggregate on Properties of Concrete. By IRJET Journal. Experimental Study on Glass Fiber Reinforced Concrete With Partial Replacement Of Cement With Ggbs And Fly Ash.

More